![background image](http://html1.mh-extra.com/html/omron/ns-series/ns-series_operation-manual_743542056.webp)
3-3
Displaying the Desired Program Section
3-3-4
Searching for Specified Instructions
54
3-3-4
Searching for Specified Instructions
It is possible to search for only specified instructions that use specific addresses. Use
the following procedure to search for a specified instruction.
1. Press
Search –Search OutputInstr
.
2. Select the Instruction Option.
3. Select the instruction from the instruction list. To specify differentiation, specify either
Differentiation Up
or
Differentiation Down
. Press the
Imm. Refresh
Button to specify
immediate refreshing. For the search range, select
All
(all tasks) or specify the task
(
Cycle Exec.
or
Interrupt
).
4. To find instructions using a specified address, input the address.
5. After the search conditions have been input, press the
Search
Button. The ladder
program section corresponding to the specified conditions will be displayed, and the
cursor will be displayed at the address that is found.
Example: Searching for OUT 6143.15 in the Cycle Execution tasks
1) Select
OUT
from the instruction list box.
2) Check that
Immediate Refresh
is not set.
3) Select
Cycle Exec.
from the
Select Task
. Press the input field of the task number
and enter 0 on the tenkey pad.
4) Select
CIO
from the operand list box.
5) Press the operand input field and input 614315 on the tenkey pad.
To continue the search for the same address under the same conditions, press the
Next
Button while the cursor is displayed at the address that was found.
Summary of Contents for ns series
