3-3
Displaying the Desired Program Section
3-3-11 Jumping from a PT User Screen to Where an Alarm Occurs
58
3-3-11 Jumping from a PT User Screen to Where an Alarm Occurs
Select the Alarm/Event Summary and History in the PT user screen. When the Ladder
Monitor is started in this state, program sections in which addresses set as alarms/events
are used as outputs can be automatically found. Either of the following two methods can
be used to perform this search.
•
Using a button to start the Ladder Monitor
•
Starting the Ladder Monitor from the Alarm/Event Summary and History
NS-series PT system version 8.0 or higher is required to start the Ladder Monitor from
the Alarm/Event Summary and History.
Note
•
When jumping from a user PT screen to a location that generated an alarm,
instructions that use offset addresses will not be found. Use an address search.
•
Using a Button to Start the Ladder Monitor
Setting Procedure
1. Arrange the Alarm/Event Summary and History and objects for starting the Ladder
Monitor on a PT user screen. Place these functional objects on the same screen. For
details on objects for starting the Ladder Monitor, refer to
Starting the Ladder Monitor
from a User Screen
on page 33.
Operations on the PT Screen
1. From the Alarm/Event Summary and History, select the alarm/event to search for.
2. Press the object to start the Ladder Monitor
Select an alarm to
start the Ladder
Monitor.
3. The Ladder Monitor will start, and a search will be automatically performed for the
program section using the address set for the alarm/event.
Summary of Contents for ns series
