3-13
Changing the Host (PLC)
88
3-13 Changing the Host (PLC)
Select the PLC (host) that is connected to the NS-series PT and registered as the host to
be monitored. It is not necessary to set the communication setting if NS-series PT and
PLC are connected as follows:
•
A PLC is connected to only to port A or port B.
•
PLCs are connected to port A, port B, and the Ethernet port, but only the PLC
connected to port A will be monitored.
Communications must be set up to monitor a PLC connected to port B when PLCs are
connected to both ports A and B, when connecting to a PLC via Ethernet or Controller
Link, or when connecting to the Controller Section of an NSJ Controller.
1. Press the
Menu
Button and select
Change Host
from the menu. The following dialog
box will be displayed.
Host names created in the CX-Designer will be shown in the list box for the selected
communications path.
2.
Select the communications path to which the desired host is connected, select the
host name to be connected to, and press the
OK
Button.
Summary of Contents for ns series
