Omron K35-2, User Manual

Page: 92 / 186

Functions and Oper
ations
Section 5 Functions and Operations
5-30
Decimal Point Position
Teaching
Use the teaching function to set the scaling input value “
ps. ax
” using
a real input.
* The K3HB-P does not support teaching.
Parameter Setting Procedure
"5.30 Using Prescale/Comparative Set Value Banks"
→
P.5-75
H Press the
M
[MODE] Key to switch the PV display to the next
parameter “
dp
.”
I Press the
S
[SHIFT] Key to make the SV display flash.
• The setting can be changed when the SV starts to flash.
J Use the
U
[UP] Key to change the set value.
K Press the
M
[MODE] Key to switch to the next parameter.
• The set value is registered.
1 s min.
L Press the
L
[LEVEL] Key for at least 1 s to return to the RUN
level.
dp
L
0
,,. ,,,
M
dp
,,. ,,,
L
0
S
dp
,,,.,,
L
0
U
nomal
out-p
L
0
M
1234. 5
1234. 5
L
After performing step B, press the
U
[UP] Key.
• Teaching is enabled and “T” flashes.
• The setting changes to match the actual input.
Press the
U
[UP] Key again.
• The entered value is set and the SV starts flashing.
Use the
U
[UP] and
S
[SHIFT] Keys to change the set value.
• Change the set value to the desired value.
Press the
M
[MODE] Key to set the displayed value.
• The prescale value calculated based on the input value and the
display value is registered, and the display switch to monitor
mode.
• In teaching status, pressing the
M
[MODE] Key cancels
teaching and switches to the next parameter.
0
ps.ax
2
T lights.
U
0
ps.ax
00002
U
0
ps.ax
00004
U
0
ps.ax
2.0000
T changes from
flashing to lit.
M
Remarks