Omron K35-2, User Manual

Page: 58 / 186

Initial Setup
Section 4 Initial Setup
4-4
4.2 Initial Setup Example for the K3HB-P
The initial setup is explained in the following example.
Settings Example
The passing speed is displayed in m/s when the distance between A
and B is 5 m.
• If the measurement value goes above 0.700, comparative output
H turns ON.
• If the measurement value goes below 0.500, comparative output L
turns ON.
Setting the Prescale Value
The prescale value can be obtained using the following formula when
the output is to be displayed in m/s.
Prescale value (
α
) = 5/60 = 0.08333 ... = 8.3333
×
10
−
2
Prescale value of Input A, X (mantissa):
ps. ax
=
8. 3333
Prescale value of Input B, Y (exponent):
ps. ay
=
10 -2
Initial Setup Flow
●
To change a set value, press the
S
[SHIFT] Key once to enable
changing the setting and then press the
U
[UP] Key to change the
value.
Press the
M
[MODE] Key to register the set value. The set value will
be registered and the next parameter will be displayed.
• The display will show “-----”.
1. Move to the initial setting level by pressing the
L
[LEVEL] Key for at least
3 s (operation will stop).
2. Set “
func
” to “
f1
” and press the
M
[MODE] Key.
1. Set input type A “
in-ta
” to “
00
” and press the
M
[MODE] Key.
2. Set input type B “
in-ta
” to “
00
” and press the
M
[MODE] Key.
A Check the wiring and turn the power ON.
B Set the function to F1 (passing speed).
C Set input type A and input type B to 00 (no-contact, normally
open).
0.500
0.700
Comparative output H
Comparative output L
Measurement
value
A
K3HB-P
B