8
Board Preparation Procedure
Section 1-6
1-6
Board Preparation Procedure
The following is the basic flow of a Board preparation.
Select one from 0 to 9.
1) Set the board ID for the CompoNet Master Board.
Mount the CompoNet Master Board on the PC.
2) Mount the Board on the PC.
When you use the Board in the Windows operation systems, install the driver.
3) Install the software.
Create a program to configure and control the CompoNet Master Board.
4) Create a program.
5) Turn on the PC.
6) Start up the created program.
7) The communication starts and the Slave Units participate.
See Section 2:
Installation and
Setup
See Section 4:
Operation by API
Functions,
Section 5:
Operation by
Shared Memory
Access, and
Appendix D:
Sample Program
Summary of Contents for 3G8F7-CRM21
