Omron 3G8F7-CRM21, User Manual

Page: 155 / 238

135
Shared Memory Area Specifications
Section B-3
B-3-9 Setting Area in Detail
This is the area in which to set the information to be notified to the CompoNet
Master Board when a command OPEN_SYSTEM or OPEN_SYSTEMEX is
issued.
Software Table
This table is used to set the number of nodes each for Word IN Slave Units,
Word OUT Slave Unit, Bit IN Slave Units and Bit OUT Slave Units. See
Section 3-1-1 for the setting items.
Data format
Offset address: 0x3900
Detailed format
Data Rate
This is used to set the data rate used in the network.
The Slave Units automatically follow the data rate of the Master Board.
The data rate is selected from 4 Mbps, 3 Mbps, 1.5 Mbps and 93.75 kbps.
10 04 The command is not in the specified format.
10 05 Header error
11 0B The response exceeds the maximum length.
22 11 The destination is in the state that cannot receive an
explicit message.
26 06 CompoNet Master Board is in initialization process. The
service cannot be executed.
26 09 It is in a state where no event can be used
End code (hex) Description
MRES SRES
Offset
(Word)
Bit
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
+0 Number of Word OUT nodes
+1 Number of Word IN nodes
+2 Number of Bit OUT nodes
+3 Number of Bit IN nodes
Name Access Description
Number of Word
OUT nodes Read/Write Settable range: 0x00 to 0x40 (0 to 64)
Number of Word IN
nodes Read/Write Settable range: 0x00 to 0x40 (0 to 64)
Number of Bit OUT
nodes Read/Write Settable range: 0x00 to 0x80 (0 to 128)
Number of Bit IN
nodes Read/Write Settable range: 0x00 to 0x80 (0 to 128)