Olympus USG-400, Maintenance Manual

Page: 40 / 90

USG-400
Inspection 5-2 ISSUE1
WARNING
Always inspect the ultrasonic generator as described in this
chapter before using. Also, inspect the ancillary equipment
used in combination with the ultrasonic generator according
to the instruction manuals. Should any irregularity be
observed, do not use the ultrasonic generator and take
proper measures by referring to Chapter 8
“Troubleshooting”. If the irregularity is still not resolved, do
not use the ultrasonic generator and contact Olympus. Using
irregular equipment may cause a malfunction and may also
result in an electric shock, burns and/or fire hazard.
Prepare the ultrasonic generator and ancillary equipment for the surgical procedure by referring to “System
chart” in Product Outline. Inspect the ultrasonic generator and ancillary equipment by referring to the respective
instruction manuals.
1 Verification workflow
The following is the equipment inspection workflow. For details on each step, read the corresponding
description.
1. Section 2 “Power verification”
2. Section 3 “Verification of communication cable connection between compatible
electrosurgical generator and ultrasonic generator (when using the THUNDERBEAT)”
3. Section 4 “Verification of touch-screen and push buttons”
4. Section 5 “Vertification of the THUNDERBEAT and/or SONICBEAT connection(s)”
5. Section 6 “Vertification of footswitch connection”
6. Section 7 “Vertification of the high-frequency(RF bipolar) output
(when using the THUNDERBEAT)”
7. Section 8 “Vertification of the alarm system”
8. Section 9 “Procedure after verification”