Olivetti d-Copia 600, Service Manual

Page: 174 / 454

1-5-18
(28)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
6).
Jam code 45 Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(29)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
7).
Jam code 46 Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(30)
A paper jam in the
eject section is indi-
cated during copying
(jam in eject section).
Jam code 50 Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
(31)
A paper jam in the
eject section is indi-
cated during copying
(jam in duplex feed-
shift section).
Jam code 60 Defective exit switch. Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Broken feedshift switch
actuator. Check visually and replace the feedshift switch if its actuator is
broken.
Defective feedshift switch. Run maintenance item U031 and turn the feedshift switch on and
off manually. Replace the feedshift switch if indication of the corre-
sponding sensor on the touch panel is not displayed in reverse.
(32)
A paper jam in the
duplex section is indi-
cated during copying
(jam in duplex inter-
nal tray).
Jam code 62 Broken duplex feed switch
actuator. Check visually and replace the duplex feed switch if its actuator is
broken.
Defective duplex feed
switch. Run maintenance item U031 and turn the duplex feed switch on
and off manually. Replace the duplex feed switch if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Check if the duplex switch-
back motor malfunctions. Run maintenance item U030 and select the duplex switchback
motor on the touch panel to be turned on and off. Check the status
and remedy if necessary.
Electrical problem with the
duplex switchback motor. Check (see page 1-5-61).
Problem Causes/check procedures Corrective measures
Service Manual Y104350-7