Olivetti d-Copia 600, Service Manual

Page: 269 / 454

1-6-39
10. Remove the mirror 1 frame from the scanner
unit, passing the lever of mirror 1 frame rear
through the hole of the scanner unit rear
frame.
Figure 1-6-77
11. Remove the round terminals of the scanner
wire in the scanner unit left side from the
scanner wire spring.
12. Remove the scanner wires from the scanner
unit.
Figure 1-6-78
(2-2)Fitting the scanner wires
Caution
When fitting the wires, be sure to use those specified below.
Machine front: gray
Machine rear: black
Fitting requires the following tools
Frame securing tools
Scanner wire stoppers
Procedure
1. Move the mirror 2 frame as shown in the fig-
ure and insert two frame securing tools into
the positioning holes at the front and rear of
the machine center to fix the mirror 2 frame
in position.
2. Fit the frame securing tools using each two
screws.
Figure 1-6-79
Lever
Mirror 1 frame
Hole
Round terminals
Scanner wire springs
Mirror 2 frame
Frame securing tools
Y104350-7 Sevice Manual