Olivetti d-Copia 600, Service Manual

Page: 63 / 454

1-3-27
[Correcting the inclination]
• If the side feeder is not level, perform the following steps to adjust its inclination.
1. Loosen the two adjustment screws.
2. Slide the fixing plate in the direction indicated by the arrow, and then tighten the adjusting screws.
3. Repeat steps 1 and 2 until the upper and lower spaces (A) between the machine and the side feeder are uni-
form.
Figure 1-3-54
[Adjusting the center line]
1. Plug the machine into a power outlet, and turn on
its main power switch.
2. Enter maintenance mode and run U034 (Adjusting
the print start timing).
3. Press the interrupt key, select the side feeder for
the test print mode, and then print a test pattern.
4. Measure the offset L (mm) between the test pattern
center (d) and the paper center (c). Next loosen the
two fixing plate screws, slide the V-groove of the fix-
ing plate from the L-guide by the same amount, and
then re-tighten the screws.
In the case of (a), slide V-groove of the fixing plate
towards the front.
In the case of (b), slide V-groove of the fixing plate
towards the back.
Figure 1-3-55
Adjusting screws
Fixing plate
A
A
a b
L
L
d
c
c
d
Y104350-7 Sevice Manual