Oki IP-5630, User Manual, Page: 118 / 265

118
Maintenance
7
Raise the wiper cleaning liquid bottle a little
and pull out the bottle after making sure that
all the liquid has flowed into the printer.
Note
‹
Visually check that the waste ink bottle is not full before
removing it.
8
Lift the wiper sponge little by little while
pulling it toward you. After confirming that
the liquid in the wiper sponge has completely
flowed in the printer, remove the wiper
sponge.
Note
‹
Just after the old wiper cleaning liquid has flowed in
the printer, liquid may overflow from the wiper sponge.
Therefore, wait at least one minute before pulling the
wiper sponge to prevent the liquid from overflowing
from the wiper sponge.
9
Install a new wiper sponge.
Insert it as far as it goes until it clicks.
10
Install a new wiper cleaning liquid bottle.
(
page 104
Wiper cleaning liquid check and
supply
)