Oki IP-5630, User Manual, Page: 110 / 265

110
Maintenance
Notes
‹
If the rubber blades are not installed correctly, the print head cleaning will not be effective. As a result not only the print
quality will decrease, but this may also lead to a malfunction.
Refer to the example below to install the blades correctly.
Protrusion
The protrusion is in the center
Parts are in contact at both the right and left sides
The spaces on the right and left are equal
They are parallel
<Correct installation>
‹
The cleaning will not be effective if the blades are mistakenly installed as shown below.
Refer to the example above to correct the position.
The blade is installed at a slant The blade is not aligned in the vertical
and horizontal directions
<Incorrect installation>
11
AFTER REPLAC. SPONGE
BLADE, CLOSE COVERS
Close the capping unit cover and the front
cover.
WIPER IS MOVING...
PLEASE WAIT
The part stops moving.
12
OPEN THE COVERS AND
REPLACE RUBBER BLADE
Open the front cover, and then the capping
unit cover.
Replace the rubber blades following the procedure from
step
8
to step
10
above.
AFTER REPLAC. RUBBER
BLADE, CLOSE COVERS
Close the capping unit cover and the front
cover.