Oce TDS400-CS, User Manual

Page: 265 / 326

Maintain the Océ TDS400-CS 265
The error messages
Error message Description / solution
'Copy too late'
'Remove paper'
'Press <on-line>' A media jam occurred. Remove the stuck media and
press on-line.
(see ‘Clear media jam in the media feed section of
the printer’ on page 270)
(see ‘Clear media jam in the fuser section’ on
page 271)
'Speed failure'
'Remove paper'
'Press <on-line>' A media jam occurred. Remove the stuck media and
press on-line.
(see ‘Clear media jam in the media feed section of
the printer’ on page 270)
(see ‘Clear media jam in the fuser section’ on
page 271)
'Knife 1 error'
'Remove paper'
'Press <on-line>' An error occurred during the cut of the roll. Check
the media on roll 1 and remove scrapped media if
necessary. Press on-line.
(see ‘Load the media’ on page 252)
'Knife 2 error'
'Remove paper'
'Press <on-line>' An error occurred during the cut of the roll. Check
the media on roll 1 and remove scrapped media if
necessary. Press on-line
(see ‘Load the media’ on page 252)
'Roll retract err'
'Press <on-line>' A media roll error. Check the media on the rolls and
press on-line.
(see ‘Load the media’ on page 252)
'Roll init error'
'Open roll unit'
'Press <on-line>' The media of a roll was not in the start position while
the printer was turned on. Place the media back into
the start position and press on line.
(see ‘Load the media’ on page 252)
'Input too late'
'Open roll unit'
'Press <on-line>' The input sheet is too late. Open the roll unit,
withdraw roll and rewind. Press on-line
'Deposit error'
'Press <on-line>' An error occurred in the compact output stacker. The
compact output stacker stops. The print process
continues.
Press <on-line>.