Oce TDS400-CS, User Manual

Page: 267 / 326

Maintain the Océ TDS400-CS 267
Printer system-messages and solutions
Introduction
The following table shows a list of system messages. You can use this table to
find a description or solution.
The system messages
System message Description / solution
'Off-line' The printer is off-line.
You can change the settings.
'Roll empty' Try the following solutions.
■
Load new media on the roll.
(see ‘Load the media’ on page 252)
■
Make sure that the media is fixed on the roll holder.
■
Make sure the media contains no bulge.
'Open left cover'
'Refill toner'
'Press <on-line>' ■
Refill the toner.
(see ‘Refill the toner’ on page 262)
'Remove original' Try the following solutions.
■
Close the top cover.
■
Make sure that all media scraps are removed.
■
Turn the printer off and on.
(see ‘Turn the Océ TDS400 printer on and off’ on page 111)
'Cutter error' ■
Make sure that the media thickness is according to the
specifications.
(see ‘Specifications Océ TCS4 scanner’ on page 298)
'Connecting...' There is no connection between the controller and the printer. Try
the following solutions
■
Wait for five minutes.
■
Turn the system off and on.
(see ‘Turn the Océ TCS4 scanner on and off’ on page 108)
(see ‘Turn the Océ TDS400 printer on and off’ on page 111)
(see ‘Turn on and shut down the Océ Power Logic® controller’ on
page 110)
'Reset printer' Turn the printer off and on again.
(see ‘Turn the Océ TDS400 printer on and off’ on page 111)