Oce TDS400-CS, User Manual

Page: 136 / 326

136 User manual
Define the original release mode
Introduction
Use the original release mode setting to define if the scanner must hold or
release the original after the scan procedure.
Before you begin
Open the Océ Settings Editor and log on as Key Operator. Take the following
steps to log on.
1.
Click 'File' and select 'Log on'.
2.
Select 'Key operator' and enter the password.
How to define the original release mode
1.
Click 'View' and select 'KO settings'.
2.
Navigate to KO - Scanner - Original handling - Original release mode.
3.
Select the required value.
You can select one of the following modes.
■
Hold the original at the front.
■
Release the original at the front.
■
Hold the original at the back.
■
Release the original at the back.
4.
Click 'Apply' to confirm the settings.
5.
Click 'File' and select 'Log off' to prevent unauthorised use.
Note:
You can also define the original release mode at the scanner operator
panel. Select 'System' - 'Original release mode' - 'Release' / 'Hold'.
Result
The original release mode is defined.