Oce TDS400-CS, User Manual

Page: 283 / 326

Maintain the Océ TDS400-CS 283
Clean the reinforcement knives
Introduction
The knives of the reinforcement unit get sticky from the glue on the
reinforcement tape. You must clean the knives regularly. If you clean the
reinforcement knives, you must put the knives in such a position that you have
access to all the parts.
You are recommended to clean the knives when
■
You install a new tape roll (see (see ‘Insert a new tape roll’ on page 273)) or
■
When an error in the reinforcement unit has occurred.
Clean the reinforcement knives
Attention:
Only use the original Cleaner K and Fixing Unit Cleaning Oil
(silicon oil) from Océ, to prevent damage to the reinforcement unit.
1.
Press the On-line key on the printer operator panel.
2.
Select ‘Folding’ with the left or right key.
3.
Press the down key to enter the ‘Folding’ menu.
4.
Select ‘Clean RU knife’ with the left or right key.
5.
Press the down key to put the reinforcement unit knives in the correct position.
6.
Open the side door of the reinforcement unit.
7.
Clean the upper and lower knife using Cleaner K.
[91] Cleaning the upper and lower knife
[91] Cleaning the upper and lower knife