User’s Guide Océ CS9060 printer
Chapter 1: Safety Instructions
12
AP-75770 – Rev 1.1 -19/11/2007,
Caution
Pay attention to the following points, while handling the power cables.
•
Do not do anything forcefully on the power cables.
•
Do not keep heavy objects on the power cables.
•
Do not bend, twist or pull the power cables by force.
•
Do not route the power cables near heating appliances.
Verify that no foreign substances such as dust are stuck on the power plugs. If you have controlled this, make sure
that the power plugs are firmly inserted to the edge of the power socket.
Mishandling of the power cables could lead to a fire.
While handling the ink cassettes, pay attention so that the ink does not get into your eyes or stick to your skin. If the
ink gets into your eyes or sticks to your skin, immediately wash off with water. It might possibly cause irritation and
light inflammation of your eyes. In case of any abnormality, consult a physician immediately.
Do not disassemble the ink cassette. If disassembled, there is a possibility that the ink might come into contact with
your eyes or skin.
Be careful that your fingers are not caught when opening or closing the media cover.
Do not operate the media set lever during printer initialization. If the carriage portion and the pressure roller portion
touch each other, there is a possibility that the printer may break down.
Do not touch the media guide during printing. It is hot and may cause burns.
Do not touch the media feed slot, platen or media guide while heaters are operating. They are hot and may cause
burns.
Do not use volatile solvents such as thinner, benzene, or alcohol. These could damage the paint.
Be careful that moisture does not enter the printer. There is a possibility that the electric circuits inside the printer
might get short circuited.
Do not open covers attached with screws under any circumstance. This could cause an electric shock or printer
breakdown.
While cleaning with the wiper
•
Do not touch the cleaning wiper and head cap unit.
Head cleaning may not be operated correctly because of the grease attached.
•
Make sure to wipe the print head with a dry poly-knit wiper.
Do not make the main body of the printer slanting or place it in a vertical position or do not keep the printer upside
down. There is a possibility that ink inside the printer may leak. Moreover, normal operation after shifting (to these
positions) cannot be guaranteed.
Opening and moving the printer to the installation place should be done by :
•
CS9060: 4 or more persons
While taking out the printer from the container box, make sure to remove the vinyl sheet and hold the handles on
the printer side. If the printer is lifted with the vinyl sheet attached, there is a possibility that the printer might fall and
might be damaged.
•
Installation of the stand to the printer should be done by 4 or more persons.
While installing the stand, be sure to switch OFF the printer power and to pull out the power plugs. It could lead to
an electric shock.
If the printer is not used for a longer period, make sure to pull out the power plugs from the power sockets for safety
reasons.
Make sure to connect an earth wire to the earth connection which meets the following standards :
•
Earth terminal of power socket
•
Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.
Set the roll media on an even surface such as a desk etc. If the roll media is set in such a way that the scroller is
standing vertical, there is a possibility that the scroller might get damaged.
Keep the working area well-ventilated. This to prevent fire and operators from feeling sick from bad air.
When printing is finished, the media guide is at high temperature. Wait until the media guide cools off.
Pay attention when you cut roll media. Mishandling the razor blade may cause a cut in your finger or hand.
•
When you hold media, do not place your finger on the media cut groove.
•
Move the razor blade along the media cut groove.
Be sure to switch OFF the power, and disconnect the power plugs when cleaning the printer.
Move the printer maintaining it in a horizontal position.
