Oce CS7400 Series, User Manual

Page: 66 / 122

3-8 Menus
• Manual Calibrations — allows you to calibrate the printer
visually, without the printer’s digital imaging sensor. Inaccu-
rate judgments by the operator during these tests could
result in substandard output. See “Manual Calibrations” on
page 4-8 for instructions.
• Service Calibrations — enables you to perform three ser-
vice calibrations: Head Height, Media Thickness Sensor,
Service Station. For best results, perform these three cali-
brations in this order. See “Service Calibrations” on page 4-
25 for instructions.
• AutoTune (roll-fed media only) — schedules jet mainte-
nance to run automatically after a certain number of prints
have printed. See “AutoTune” on page 4-4 for instructions.
• Calibration Summary — prints summary information with
the AutoSet calibration test patterns, or transmits registra-
tion or jet data to a log file on the print server.
• Configure for Profile Creation (cut sheet printing only) —
causes all calibration prints to print on the same cut sheet,
rather than ejecting the sheet after each calibration print.
Automatically disabled after all calibration prints are fin-
ished, when a print job is received from the RIP, or when
roll-fed media is loaded. The user can specify a dry time
delay after which the linearization will begin.
Printer Settings
To display this menu, press the Settings button on the Front
Page screen. Printer Settings enables you to set many options
that control how the printer operates. Settings saved by the
Media Wizard are indicated by
MEDIA WIZARD
in the margin.
MEDIA WIZARD
• Platen Vacuum Control — turns on the vacuum fans, then
allows you to raise or lower the fan speed. Raise the speed if
the media is warped and rising off the platen, lower the
speed if the media is buckling or wrinkling. Turn off the vac-
uum fans for lightweight media.
Optionally, you can enable Leading Edge Static Control to
reduce overspray in areas of fine text at the leading edge of
a rigid media print. This lowers the platen vacuum level until
the leading edge of the media has passed over the front
edge of the platen. Disable if the media needs full vacuum
for good media feed.