Oce CS7400 Series, User Manual

Page: 52 / 122

2-22 Printing Tips
Calibrating the
Moveable Fence
The moveable fence is calibrated at the factory to be parallel to
the top surface of the media, at a height just above the top of the
table rollers (lower than the thickest media that will be used on
the printer).
If the moveable fence needs to be recalibrated, follow this
procedure:
1. Place a piece of rigid media under the pinch rollers, and
align it against the stationary fence.
2. Slide the moveable fence next to the edge of the media and
observe its position relative to the top surface of the media.
3. If the fence is not parallel to the top edge of the media, use a
2.5 mm hex wrench to turn the position screw (shown below)
until the moveable arm is parallel with the media.
Fig. 2-12. Location of position screw