Oce CS7400 Series, User Manual

Page: 38 / 122

2-8 Configure Media
Observe the media as the fan speed changes. If the
media is lifting off the platen, increase the fan speed. If
the media advance seems impeded by the vacuum,
decrease the fan speed.
After you save your changes by pressing the

(Pro-
ceed) key, the Leading Edge Static Control screen
appears. This feature reduces overspray in areas of fine
text in the first 0.6 inches (15 mm) leading edge of a rigid
media print. Disable if the media is not being held suffi-
cently onto the platen.
• Printing Delay — press the

and

keys on the con-
trol panel to increase or decrease the delay (seconds per
print swath). To increase throughput, decrease the delay.
• Media Edge Holders — if Yes, you will be prompted dur-
ing the media load sequence whether you are using the
media edge holders for rollfed media. If No, you will not
be prompted.
• Media Out Sensor — the sensor is used to detect the
trailing edge of cut-sheet media so that printing can be
stopped before running out of media. The sensor should
be disabled only for media types it cannot detect, or if the
sensor is malfunctioning.
• Measure Media Width — select Automatically to mea-
sure the media with the digital imaging sensor (camera),
or Manually to position the printhead carraige at the right
and left edges of the media, or when loading transparent
media, the edges of which cannot be detected by the
printer.
4. Press

(Proceed) to load the media, or press

(Cancel)
to discard your changes.
• To load media, go to “Load and Print on Rigid Media” on
page 2-10 or “Load and Print on Roll-Fed Media” on page
2-15