Nuova Simonelli Appia II, User Handbook Manual

Page: 44 / 150

40
ENGLISH
If the cup warmer is not enabled, the key
will only switch on during the Flash-test, after
which this key will have no effect when pressed.
Press the continuous key of the sec-
ond group to store the modified values and exit
the page for setting machine operating param-
eters.
6. Restoring default settings
It is possible to restore default settings, i.e.
pump level, water with pump, maximum bright-
ness and cup warmer enabled.
To restore these parameters, it is sufficient to
switch on the machine using the
key
then to press the 2 espressos and 2
long coffees keys of the first group at
the same time.
7.8
AUTOMATIC GROUP
CLEANING CYCLE
To enter the automatic cleaning mode, switch
the machine off and then on again, holding
down the hot water
and cup warmer
keys during the initial Flash-test.
At the end of the Flash-test, the and
keys and the single long coffee key
of all groups will begin to flash.
Press the key to start the washing
cycle for the relevant group.
Once the washing cycle has been completed, it
is possible to perform a rinse cycle for the same
group by pressing the
key again.
To perform the rinse cycle at a later time, switch
off the machine and the card will store any
cleaning cycles that need to be completed in its
memory. In fact, the next time that the machine
is switched on, the machine card will automati-
cally open the group cleaning status without it
being necessary to press the and
keys.
Hold down the and keys for 2
seconds to exit the cleaning mode in the event
that there are no cycles to be completed. For
incomplete cycles, the
keys of the
groups that require rinsing will continue to flash.
Hold down the and keys for 2
seconds more to force exit from the cleaning
mode, resetting all information about rinse
cycles still to be completed.
When a cleaning cycle is complete,
the key for the group will switch off.
If there are no more rinse cycles to be per-
formed, the card will exit the cleaning mode.