2 SafeCom Controller
D60700-07
42
2.9.2
Update software via Mini-FTP
This software update method clears all settings, including the IP address.
Note:
The SafeCom Controller does not respond to ping request while in mini-
FTP mode.
You can bring the SafeCom Controller into mini-FTP mode by holding the test
button while you power on the SafeCom Controller, or from the SafeCom
Controller web interface.
1.
Open the
Advanced Configuration
web page.
2.
Click
Restart to mini-FTP
.
The SafeCom Controller prints a page with the text "Awaiting microcode
download..."
3.
Log on as an administrator and issue the
arp
command from the command
prompt.
Syntax:
arp -s <IP Address> <MAC Address>
The MAC address can be found on the rear side of the SafeCom Controller.
If you want to use the IP address: 194.192.134.86 for the SafeCom
Controller and the 12-digit hexadecimal MAC address is 00C076FF00F2.
Enter:
arp -s 194.192.134.86 00-C0-76-FF-00-F2
4.
Use the
ping
command to give the SafeCom Controller its new IP address.
Issue the
ping
command from the command prompt. Enter:
ping 194.192.134.86
5.
From the command prompt issue the
ftp
command. Enter:
ftp <IP address>
The SafeCom Controller prompts you for a username and a password. Both
are
adm
by default.
6.
Set the binary transfer type and download (
put
) the software file. Enter:
binary
hash
put <software file>.b80
The software is updated. The SafeCom Controller automatically restarts
after a successful update and CRC check.
7.
Logout of the ftp session. Enter:
quit
