2 SafeCom Controller
D60700-07
23
2.6.3
SafeCom MFP Cable HP 9055mfp and 9065mfp
The MFP’s FIH connector is located behind the MFP’s back cover. See pictures
below. Remove the back cover. Remove the male connector with the two wires
and connect the equivalent black connector from the supplied SafeCom MFP
cable.
1.
Power on the MFP under the 25 service mode. First ensure that the main
power switch on the back of the MFP is turned on and the sub-power
button on the front of the MFP is turned off. Then, while holding down
the keys “2” and “5” on the control panel, turn on the sub-power button
(SW2). The Memory setting mode menu screen will appear.
2.
Select the “Software SW setting” menu.
3.
Set Dipswitch 4-4 to ON (1) so that Key Counter removal recovery is
enabled.
4.
Set Dipswitch 9-0 to OFF (0) so that the operation at key counter removal
(copy) is the same as the stop key, instead of immediate stop (jam).
5.
**OPTIONAL
—To change the message displayed when FIH becomes
disabled, set Dipswitch 9-2 and 9-3 using the following table:
Mode
9-2
9-3
Please insert key counter.
0
0
Please insert coin.
0
1
Please insert copy card.
1
0
Please insert key counter.
1
1
6.
Press “Return” to exit the “Software SW setting” menu.
7.
Power-cycle the copier using the sub-power button.
8.
Turn on the external job accounting device.
Note:
If you try to make copies without being logged in via SafeCom, the MFP’s
control panel displays
Please insert key counter.
