2 SafeCom Controller
D60700-07
36
2.8.4
Select user identification
1.
Open the
Advanced Configuration
web page (2.7.2).
2.
Click
SafeCom
. Change
Front End Identification
.
3.
Click
Save and Continue
to save your settings.
4.
Select
Restart
. Click
Restart
again.
You must wait approx. 1 minute while the SafeCom Controller initializes.
2.8.5
Disable the test button
To prevent unauthorized users from restoring factory defaults, disable the
SafeCom Controller’s test button.
1.
Open the
Advanced Configuration
web page (2.7.2).
2.
Click
General
.
3.
Change
Enable Test Button
to
NO
.
4.
Click
Save and Continue
.
5.
Click
Restart
.
2.8.6
Add driver names
The
Driver name
is the same as the
Model
listed in Windows on the
General
tab of the
Printer properties
dialog.
1.
Open the
Advanced Configuration
web page (2.7.2).
2.
Click
Printer
.
3.
In
Driver names
enter the name of the drivers you believe are compatible
with the printer. Documents generated with these drivers will not cause a
fidelity warning if there is a mismatch.
4.
Click
Save and Continue
.
5.
Click
Restart
.
2.8.7
Assign a fixed IP address to the SafeCom Controller
The IP address can be assigned via DHCP (dynamic or fixed) or manually. The
steps below describe how to assign a fixed IP address via the SafeCom
Controller web interface.
1.
Open the
Advanced Configuration
web page (2.7.2).
2.
Click
TCP/IP
.
3.
Check
Manual
and enter the
IP address
etc.
4.
Click
Save and Continue
.
5.
Click
Restart
.
