NSD VARICAM VS-5F Series, Specifications And Instruction Manual

Page: 116 / 130

106
APPENDIX APPENDIX 1. PASSWORD FUNCTION
APPENDIX 1. PASSWORD FUNCTION
This function is applied to all models that are written "SP1" in the lower right portion of the front panel.
This is the function to ask inputting the password when the mode of VARICAM changes from the operation (RUN)
mode.
Customers can pick and set the password which consists of 3 digits of numeric values.
The mode cannot be changed without the password after setting numbers; therefore, the value of “switch setting”
and “parameter setting” can be protected. It can also be protected from changing the program No. from panel side.
If the password is not set, the mode could be changed by conventional operation.
APPENDIX 1-1. Password Setting Flow
The flowchart of setting the password is shown below.
A change or deletion of the password is the same as the following operation.
For more details regarding the setting procedure, refer to “APPENDIX 1-3. Password Setting Procedures”.
Displays the mode selection
screen.
Inputs the password which is
already set.
Inputs the new password.
Inputs the new password again.
Start
END
Returns to the mode which is just
before inputting the password.
Displays the password edit
screen.
･･･
Displays the mode selection screen by pressing [MODE] key on the panel side.
“
RUN” is blinking in the POSITION display area.
･･･
Displays the password edit screen.
･･･
The initial value is set "000" (Factory setting value).
Keep the value “000” and go to next step when setting the password for the first time.
Inputs the password which is already set when changing it.
･･･
Inputs 3-digit of numeric value as new password.
Setting range: 001 to 999
Inputs “000” when canceling the password function.
･･･
Inputs the new password again for the confirmation.
Reset the new password if the input password is incorrect.
･･･
When password setting is completed, returns to the mode which is just before
inputting the password.