Novanta Precession Elephant 2, User Manual

Page: 53 / 103

PRECESSION ELEPHANT 2 Scan Head 2 Instruction Manual 2021-09-22
4.
CAUTION
Visible or invisible laser radiation
could cause damage to eye or skin.
• Avoid eye or skin exposure to direct or scattered radiation.
Start the Job.
The Job draws a square on the work piece that is filled with a hatching.
If the parameters in
linepar
(line parameters) are set correctly then the
square’s outline is closed and t
he hatching ends at the outline as in the
following figure.
not OK OK
5. If the above condition is OK then proceed with subsection 6.7.5 on page 54 .
6. If the above condition is
not
OK then
a. In the
Navigator
view, click Pens

default

linepar .
TIP
With each repetition change only one of the parameters mentioned
below.
b. On the
Times
tab in group
Open end
, set
On delay
and
Off delay
such
way that the horizontal hatching begins and ends at the 2 vertical lines.
c. In group
Joint 2
, set On delay and Off delay such way that the corners of
the square look good.
d. Insert the work piece and repeat this procedure from step 4 on page 53 .
53