Novanta Precession Elephant 2, User Manual

Page: 23 / 103

PRECESSION ELEPHANT 2 Scan Head 2 Instruction Manual 2021-09-22
No. Label / description Action
⑦ SYNC
connector for the laser’s trigger
signal
output
This connector is optional.
If you wish to measure the
energy of single laser pulses
then connect it with a BNC-
cable to trigger signal output
of laser.
Find more information in
[
Firmware ] in section
Devices:Sensor

AfemLight
.
⑧
BEAM SWITCH connector for control of an
external beam switch
This connector is optional.
If a beam (path) switch is
present in your system then
connect with a CAT-5 patch
cable to the beam switch.
⑨ USB 1 USB 2 USB 3 connectors for the built-
in through-the-lens vision camera and
2 alignment cameras
If USB cameras are built-in then
connect this to a PC.
See also [
uEye ].
⑩ Beam entry None
⑪ Objective None
⑫ Optionally adjustable gas nozzle and optional
suction cup None
⑬ ETHERNET connector for connecting the built-
in through-the-lens vision camera and
2 alignment cameras
If Ethernet cameras are built-in
then connect this to a PC.
See also [
uEye ].
⑭ NOZZLE
Process gas inlet;
Process gas quality: non-corrosive gases used
commonly as process gases;
Inlet pressure: depending on nozzle up to 4 bar
(400 kPa);
Recommend tubing material:
polyetherurethane; D 6 mm, d 4 mm
Connect with tube to process
gas supply; see also section
5.6
on page 28
23