Nortel RLC, Installation And Administration Manual

Page: 227 / 466

RLC Installation and Administration Guide 201
June 2005 Configuring the RLC
PSTN configuration
To allow a remote unit to establish PSTN connections with the RLC:
1 Click on the Enable option button located in the PSTN: Status section to
use the PSTN mode with the remote unit indicated in the Unit ID field.
2 Click on the Yes option button located in the PSTN: Configure section to
manually configure the PSTN number used by the RLC for initiating a
PSTN connection to the remote site.
3 Enter the PSTN number that the RLC must dial to connect to the remote
unit in the PSTN Number field.
You must configure PSTN numbers including, the ISDN numbers, in a specific
manner. Please read the following examples carefully.
Configuring seven-digit ISDN numbers
If the service documents supplied by the BRI service provider contain a seven-
digit ISDN number, then choose from among the following options to configure
the number on your Remote Gateway 9100 Series unit:
„
Remote Gateway 9150 unit BRI configuration
Configure the PSTN numbers with the seven digits provided by the Central
Office without area codes. For example:
— 5551000 configured against the corresponding B-channel, not
2145551000
„
RLC Remote Connection Configuration
Use the # delimiter to separate the Trunk Access code and area code part of
the PSTN number. For example:
— #9#5551000 (not 95551000) where “5551000” is the primary Remote
Gateway 9150 B-channel
— #91214#5551000 (if long distance between units), not 92145552000
„
RLC Network Port configuration
Enter the Network Port PSTN Number exactly as the Remote Gateway
9100 Series unit must dial it. For example:
— 5552000 (for seven-digit local call) where 5552000 is a PBX DID data
port number
— 12125552000 (if long distance)