Nortel Passport 7400, Hardware Installation, Maintenance, And Troubleshooting, Page: 414 / 438

414 Chapter 37 Hardware procedures
241-7401-240 5.2S1
Unpacking a 3-slot Passport switch
Unpack a 3-slot Passport switch close to the installation site.
Prerequisites
• Nortel ships mounting kits in separate boxes. Unpack your mounting kit
and place the parts to the side until you are ready to mount the chassis.
Procedure steps
1 Place the termination panel boxes to one side. Do not unpack them.
2 Set the box on the floor with the top end up.
3 Cut the tape that seals the top flaps, taking care not to cut into the
contents of the box, and fold back all four flaps.
4 Remove the foam from the top of the chassis.
5 Lift the chassis from the box and set it on the floor or table.
6 Remove the packing material from the chassis.
7 Unpack any other equipment that was delivered with the switch.
8 Compare the contents of your shipment with the table “Equipment
checklist for the 3-slot Passport switch base package” (page 415) and the
figure “Taking inventory after unpacking a 3-slot Passport switch”
(page 416) to ensure you have all the hardware you require.
CAUTION
Risk of electrostatic damage
To avoid electrostatic damage, do not unpack the
termination panels at this time. When handling processor
cards, always wear antistatic footwear or provide
equivalent protection to avoid electrostatic damage to
electronic parts.