60
Chapter 4 Installing option cards and DIMMs
314711-D Rev 00
To install or replace an interface card or a Hardware Accelerator card:
1
Shut down the Contivity 1700 using the Web GUI or the command line
interface and then unplug it as described in
“Shutting down the system to add
or replace hardware” on page 54
.
2
Remove the front bezel from the chassis, then remove the chassis from the
equipment rack (see
“Removing the front bezel and top cover” on page 55
).
3
Remove the top cover from the chassis (see
“Removing the front bezel and top
cover” on page 55
).
4
Attach the antistatic wrist strap that was shipped with the Contivity 1700 (see
“Attaching the antistatic wrist strap” on page 58
).
5
Locate the slot where you plan to install the new or replacement option card.
Danger:
Turn off the Contivity 1700 and unplug it before you attempt
to install an option card.
Note:
If no option cards are installed in the Contivity 1700, install the
new option card in the lower slot.
Summary of Contents for 1700
