56
Chapter 4 Installing option cards and DIMMs
314711-D Rev 00
The first few times that you remove the front bezel, it may be somewhat
difficult to remove because the ball studs and socket clips are new.
To remove the top cover:
1
If the Contivity 1700 is installed in an equipment rack, remove it from the
rack.
a
At the front of the chassis, remove the 2 panhead screws that secure the
bottom of the chassis to the equipment rack.
b
Remove the Contivity 1700 from the rack-mount shelf and set it on a
sturdy surface.
2
Using a Phillips screwdriver, remove the 4 screws that secure the cover to the
chassis
(Figure 18)
.
Figure 18
Removing the top cover
3
Slide the top cover forward approximately 1/4 inch.
CS160003A
Slide cover forward and lift up
Remove these 4 screws
Alert/Firm
Boot/Ready
Alert/Fail
Boot/Ready
Summary of Contents for 1700
