13
EN
6 Basic Operation
Start
WARNING
z
z
Make sure to properly connect the connection plug of the power cord and power plug.
z
z
Always make sure the tool is grounded.
No grounding the tool could cause failure or electric shock at the time of electrical leakage.
If you are not sure about the grounding of the outlet, request an electrical contractor to check if it is grounded.
When an extension cord is used, use a 3-core cord that includes a ground wire.
z
z
Make sure to properly connect the connection cord.
Other than supplying power, the connection cord is connected to the ground to eliminate static electricity.
The end metal section of the electric screwdriver is connected to the ground of the dedicated power supply via a
1 MΩ safety resistor inside the electric screwdriver.
Also, when the tool is used for a long time, the rotation part of the electric screwdriver becomes worn and the
ability to remove static electricity decreases. Periodically request your sales agent to perform an overhaul on the
tool.
1
Use the connection cord to connect the electric
screwdriver and dedicated power supply
Check the orientation of the plug of the connection cord and
insert all the way to the end.
Turn the sleeve clockwise and secure firmly.
Rib
Rib
Cut-out
Sleeve
Power driver (male pin)
Connection Cord (female pin)
Dedicated power supply (male pin)
2
Insert the connection plug of the power
cord to the dedicated power supply
3
Insert the power plug into a grounded outlet (100 VAC - 240 VAC) to supply electricity
4
Turn ON ( I ) the power switch of the
dedicated power supply
The power supply switch lights in green.
When the switch is turned OFF (
¡
), the light goes
out.
TV07521-1_DLV30S12P-AYK_en.indb 13
2017/02/10 15:56:31
