10
11
01b
Slide 8 x T-Nuts into the outside channel of the Right Base Member.
Video Instruction: bit.ly/nlrbuild
10
11
Note:
For easier installation hand
screw M8 bolt into T-Nut to assist
sliding T-Nut into channel.
FRONT
BACK
IMPORTANT:
Place T-Nuts as shown in diagram below on the
OUTSIDE
of Right Base
(Red dots are T-Nuts placement)
Note:
Slide 2 x
T-Nuts to front for
Pedal Support
Note:
Slide 4 x T-Nuts
to middle for Wheel
Post
Note:
Slide 2 x
T-Nuts to rear for
Seat Sliders
LEFT
RIGHT
REAR
FRONT
PARTS:
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
04
Align the threaded holes on the Front and Rear Base Members with the pre-drilled holes on the Left
Base Member. Bolt through and secure with M8 Bolts and Washers.
PARTS:
• • Cable Management Clip
03
Suggested 1 x Cable Management Clip installation into the top channel of the Rear Base Member.
Note:
Depress locater tab on back
side of clip to install into channel.
PARTS:
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
02
Align the threaded holes on the Front and Rear Base Members with the pre-drilled holes on the Right
Base Member. Bolt through and secure with M8 Bolts and Washers.
FRONT
REAR
RIGHT
LEFT
REAR
RIGHT
