Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x T-Nuts
• • 4 x Adjustable Feet
05
PARTS:
• • Upright Connection Plates
• • 8 x M8 35mm Bolts
• • 8 x M8 Washers
10
Align the threaded holes on the Upright Connection Plates with the holes on the Vertical Post. Bolt
through and secure using M8 Bolts and Washers. Repeat on the other side.
PARTS:
• • 4 x M8 20mm Bolts
• • 4 x M8 Washers
12
Align the Left Vertical Post assembly with the T-Nuts previously installed in STEP 01a.
Bolt through and secure with M8 Bolts and Washers.
PARTS:
• • 4 x M8 20mm Bolts
• • 4 x M8 Washers
11
Align the Right Vertical Post assembly with the T-Nuts previously installed in STEP 01b.
Bolt through and secure with M8 Bolts and Washers.
Slide 4 x T-Nuts into the bottom channels of the Base Assembly as shown.
06
Align the NLR Height Adjustable Foot with the
T-Nuts previously installed in
STEP 05.
07
Install the NLR Height Adjustable Foot into T-Nut
previously installed in
STEP 05.
08
Align the tab on the NLR Height Adjustable Foot
with the extrusion.
09
Tighten the screw inside the NLR Height Adjust-
able foot with an Allen Key. Install Rubber Plug.
Note:
Foot alignment tab
should sit in the channel.
(
FRONT
)
(
BACK
)
(
FRONT
)
(
REAR
)
Note:
Parts are labelled for
left and right side application
(L)
(R)
Note:
Recess holes
facing outward.
(L)
(R)
Note:
Height of the foot can be adjusted only
when it’s installed on to the cockpit.
