New Holland 200 Series, Operator'S Manual

Page: 95 / 292

3 - CONTROLS AND INSTRUMENTS
INSTRUMENT CLUSTER
Electronic Instrument Cluster (EIC)
The Electronic Instrument Cluster (EIC) is on the right-
hand cab post.
Once in the seat, the alarm sounds and selected lamps
illuminate briefly. Monitor these lamps on a daily basis
to confirm that they will function in the event of a system
alarm. The fuel gauge and hour meter will remain illumi-
nated for operator monitoring.
When started, the machine will be in park with the park
brake lamp
(1) illuminated. The park brake switch (3) is
on the lower right-hand instrument panel.
The operator must be in the seat with the seat belt fas-
tened and the restraint bar lowered (if equipped). After
the operator starts the machine, the operator must push
the OPERATE button
(2) to activate the loader arms and
ground drive.
A semi-hidden “Setup” menu allows the user to view, se-
lect, change, and customize a number of machine set-
tings. A security code may be entered into the Instrument
Cluster. Once the security code has been entered, each
user will have to enter the code before the machine will
start. Contact your dealer for detailed information on the
“Setup” menu and security feature activation.
NOTE: Fault code definitions are located in the trou-
bleshooting section. The updated fault code is visible to
the operator on the display on the right-hand column.
NOTICE: Low hydraulic charge pressure will cause en-
gagement of the park brake. With an Electro-Hydraulic
(EH) control unit, the park brake lamp will flash and an
audible alarm will sound, if this condition exists.
93109329A
1
3-35