New Holland 200 Series, Operator'S Manual

Page: 207 / 292

7 - MAINTENANCE
EVERY 50 HOURS
Cab intake filter
If the machine is equipped with a cab heater or air conditioning, the cab intake filter should be inspected as shown.
The cab intake filter
(1) is located inside the cab behind the seat below the rear window.
NOTE: The service interval for the cab intake filter is dependent on the amount of use and the operating conditions.
It is recommended to check more often if working in extreme environmental conditions.
1. Open the access cover using knobs (2) . Replace the
cab intake filter if it is damaged, torn, or if it is clogged
with debris and dirt.
93106883
1
2. Remove the cab intake filter (3) .
NOTICE: Maintain the filter in a horizontal orientation when
removing from the air box. This will prevent dust and debris
from being accidently dumped in the cab.
93106884
2
3. Clean the cab intake filter compartment of dirt and de-
bris. The rubber gasket on the filter must seal properly
with the compartment filter flange.
4. Replace the new or cleaned components in the reverse
order.
93107489A
3
NOTICE: Make sure to get a good seal between the filter and the housing.
7-43