New Holland 200 Series, Operator'S Manual

Page: 70 / 292

3 - CONTROLS AND INSTRUMENTS
Lift arm and bucket controls
Hand controls
93109347C
1
Lift arm raise and lower control.
• The left-hand control lever
(1) controls the lift arm. The
lift arm will raise by pivoting the handle “UP” to the out-
side of the cab. Pivoting the handle “DOWN” to the in-
side of the cab will lower the lift arm.
• The lift arm spool is equipped with a detented “FLOAT”
circuit if the operator wants the lift arm to float over
changing ground contour. To put the valve in “FLOAT”
position, pivot the left handle “DOWN” until a slight
“jump” is felt. In this position, the handle is locked in
float and does not return to the neutral position unas-
sisted, but will do so when light pressure is applied to
the handle to pivot it “UP”.
BT06H186
2
Bucket dump and curl control.
• The right hand control lever
(2) controls the bucket. The
bucket will dump by pivoting the handle “UP” to the out-
side of the cab. Pivoting the handle “DOWN” to the in-
side of the cab and the bucket will roll back (curl).
NOTE: There is no detent or float position on the bucket
dump or curl spools.
BT06H187
3
3-10