NETGEAR ProSafe GSM7228PS, Cli Manual, Page: 272 / 569

ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
Power Over Ethernet Commands 5-7
v1.0, May 2010
Low - Low Priority
no poe priority
This command sets the priority to default.
poe reset
This command resets reset a specific port. When the poe port status is shown to be in Error state,
this command can be used to reset the PoE port. The command can also be used to reset the power
delivering ports.
poe reset auto
This command is used to set the Autoreset mode. When Autoreset mode is enabled, the
PoE port will be automatically reset if we detect an error on the port like Overload etc. By
default the Auto Reset mode is enabled. This command will let you set the mode on a per
PoE unit basis or all PoE units.
Format
poe priority {Crit | High | Low}
Mode Global Config
Interface Config
Default low
Format
no poe priority
Mode Global Config
Intrerface Config
Format
poe reset
Mode Global Config
Interface Config
Format
poe reset auto {<unit>|all}
Mode Global Config
Default Enabled