ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
Power Over Ethernet Commands
5-4
v1.0, May 2010
no poe detection
This command sets the detection mode to default on a global basis or per interface.
poe high-power
This command switches a port from 802.3af mode to High Powere mode. This mode is used to
power up devices that require more power than the current IEEE 802.3af power (more than 12.95
Watts at the PD). When switching to High Power mode, make sure that the device is a Class 4
device.
Three options are available:
legacy
- use this mode if the device can power up (more than 12.95 Watts) with higher current
and it cannot identify itself as Class 4 device.
Note:
Only ports 1-8 support this high power.
pre-dot3at
- Use this mode if the device cannot identify itself as Class 4 device and it does not
have LLDP support.
dot3at
- Use this mode if the device is a Class 4 device capable of figuring out power
requirement through LLDP.
no poe high-power
This command disables the High Power mode. The port will only support IEEE 902.3af devices.
This command works on a global basis or per interface.
Format
no poe detection
Mode
Global Config
Interface Config
Format
poe high-power {legacy | pre-dot3at | dot3at}
Mode
Interface Config
Default
Disable
Format
no poe high-power
Mode
Interface Config