46
Zhejiang Neoden Technology Co., Ltd
11.2 Installing tape and reel components
figure 1
figure 2
1. Making the feeder in open status to wait for installing the tape reel
①
Lift up the feeder fixing handle
；
②
Press the
material-sending handle with left hand
③
meanwhile press the lamellule at right side of the feeder with your right hand
；
loosen the material-sending handle, ensure the proper wrapped (see figure 1) then loosen the lamellule
2. Installing the tape and reel components: setting the reel on reel storage at the back side of the feeder, pull out
approximately 10cm length tape, separate the film and tape, then put into transfer storage (see figure 1).The tape should be
closely matched with the gear, and the film should pass through the upper denomination groove (see figure 2) through two
white guide wheels and then be sandwiched between two gears.
Fig 3
3. Finish installing tape and reel components.
