NEC Versa LX, Service And Reference Manual

Page: 44 / 138

2-20 System Configuration and Setup
„
Silent Boot — Specifies whether or not to display the NEC logo during
system boot.
„
Boot from Docking Station IDE — Specifies whether or not the system
boots from the docking station IDE device. (Only when the NEC Versa is
docked.)
„
Boot Display Device — Specifies the display device(s) to show the
system boot messages on.
„
Docking Station Video — Selects whether or not a video card installed in
the Docking Station is enabled at system boot.
„
BootUp NumLock — Specifies whether NumLock is On or Off at system
startup.
„
Boot Devices — Specifies the sequence of boot devices and whether or
not the system attempts to boot from a device other than those specified.
„
Other Boot Devices — Allows you to specify IDE devices as bootable
devices.
Peripheral Setup
The Peripheral Setup menu displays the connection locations between the
system and the Input/Output (I/O) ports. This menu also lets you specify
different port assignments as needed.
Note:
If you disable a device in Peripheral Setup, you
cannot enable or assign it using the Windows 95 device
manager. The device is not listed in the Windows 95 device
list. To control the device using the Windows 95 device
manager, select any setting other than Disable in Peripheral
Setup.
„
Internal Hard Drive — Allows you to enable or disable the internal hard
drive.
„
USB Controller — Allows you to enable or disable the USB controller.
„
Serial Port — Allows you to disable the port or change its address
assignment.
„
Parallel Port/Parallel Mode — Lets you disable or reassign the parallel
port and select a parallel port mode.
„
IR Serial Port — Allows you to enable, disable or reassign the IR serial
port.