NEC VERSA DOCK - SERVICE, Service Manual

Page: 37 / 121

System Configuration and Setup 2-21
2.
Remove the CRT table from the NEC Versa Dock.
3.
Release the NEC Versa from the NEC Versa Dock by firmly pulling the
front of the NEC Versa with equal pressure to the right front and the left
front.
4. Continue to pull until the NEC Versa is free from the NEC Versa Dock.
Releasing the NEC Versa from the NEC Versa Dock
Installing Options and Connecting Devices
You can optimize your NEC Versa’s functionality by installing options in the
NEC Versa Dock. Options can be installed in the following bays and slots:
n
File Bays — two file bays on the front of the NEC Versa Dock give you
external access to installed devices.

In the left front file bay, you can install any optional 5.25-inch IDE
device, and with a 3.5-inch Universal Installation Kit, you can install
any 3.5-inch IDE device.

In the right front file bay you can install any optional IDE device or
the optional VersaBay III Adapter Kit. With this Adapter Kit, you can
change this file bay into a VersaBay III slot that lets you use your
VersaBay III devices in the NEC Versa Dock.
n
Two PCI Board Slots — Two slots let you add two PCI cards to your
NEC Versa Dock. One slot supports a full-size card and both slots
support a half-size PCI card.
n
I/O ports on the sides and back of the NEC Versa Dock let you connect
the following external devices:

Parallel device

External monitor

Serial device

PS/2 keyboard and PS/2 mouse (separate ports for each)