NEC VERSA DOCK - SERVICE, Service Manual

Page: 23 / 121

System Configuration and Setup 2-7
Docking and Undocking
Getting the NEC Versa Dock up and running is easy. These next few pages
provide the procedures to get started. They include:
n
Connecting the power cable to AC power and to the NEC Versa Dock.
n
Preparing the NEC Versa for docking and docking it on the NEC Versa
Dock.
n
Powering on the NEC Versa.
This chapter also describes normal and emergency undocking when you want to
use the NEC Versa by itself.
Connecting the Power Cable
Follow the instructions given next in the order presented to get your NEC Versa
and NEC Versa Dock up and running.
Connect the AC power cable to the NEC Versa Dock and
AC power before docking the computer.
The power cable that came with the NEC Versa Dock provides power to both
the NEC Versa Dock and the NEC Versa when docked.
If you need to replace the NEC Versa Dock power cable,
make sure it meets the following specifications:
n
In North America, the cable should be rated for 120 V, 7
A. The plug is a NEMA 5-15P. Use an SVT or SJT 18/3
AWG cable that is less than 15 feet (4.5 m) long. Use
connector type IEC320.
n
In Europe, the cable should be rated for 230 V (220-240
V), 10 A. The plug is country-specific. Use an H05VV-F
or H05VVH2-F cable that is less than 15 feet (4.5 m)
long. Use connector type EN60320.
Connect the power cable as follows.