Disassembly and Reassembly 3-29
!
CAUTION
If the board does not slide when you push the latch, slide the
board out of the unit a bit and check the alignment position
(see the previous figures). Push the latch closed.
5.
If the system board is aligned correctly, you might need to push the outside
edges of the board to fully seat it into the riser board connector.
6.
Check the position of the chassis latch. The system board is secured when
the latch is parallel with the outside edge of the board (see the following
figure).
Secured Position of Latch
A – Latch Closed
C – Edge of System Board
B – Edge of Chassis
7.
Replace the graphics board in the AGP slot. Secure the board with the
expansion slot screw.
8.
Replace the cover.
Removing the Plastic Rail
Remove the plastic rails from the system board as follows.
1.
Remove the system unit cover as previously described.
2.
Remove the system board as previously described.
3.
Place the system board on a level static-free surface.
4.
Remove the four screws holding the two plastic rails to the underside of the
system board (see the figure on the following page).
Summary of Contents for POWERMATE 8100 Series
Page 17: ...1 System Overview Configurations Features Components ...
Page 131: ...4 System Board Connectors Jumpers and Sockets Components Pin Assignments Resources ...
Page 189: ...7 Preventive Maintenance System Cleaning Keyboard Cleaning Mouse Cleaning ...
