NEC POWERMATE 8100 Series, Service And Reference Manual

Page: 108 / 273

Disassembly and Reassembly 3-11
3.
Unplug the cable from the feature connector.
4. Remove the screws from the front of the switch board/IR panel.
5. Remove the switch board/IR panel.
DIMM Removal
Remove a DIMM from the system board as follows.
1. Turn off the system and disconnect the system power cord.
2. Remove the system unit cover (see “Removing the Cover”).
3. Locate the DIMM sockets on the system board.
4. Eject the module by pressing the plastic clips at the outer edges of the
DIMM socket away from the memory module (see the following figure).
Removing a DIMM
A – Plastic Clip
AGP Board Removal
Remove an AGP board as follows.
Note:
If removing a PCI graphics board, use the
removal procedures for an expansion board (see “Expansion
Board Removal”).
1.
Turn off the system and disconnect the system power cord.
2.
Remove the system unit cover (see “Removing the Cover”).