CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
PN-2DPCB (DPC)
NEAX2000 IVS
2
Installation Procedure Manual
ND-70928 (E), Issue 1.0
Page 359
The figure in the SWITCH NAME column and the position in
in the SETTING POSITION
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and
, the setting of the switch varies with the system concerned.
NOTE:
When the power is on, disconnect the cables before unplugging the circuit card and
connect the cables after plugging the circuit card.
SW0 (DIP SW)
1
ON
No. 0
Circuit
Forcibly turning the DTR
signal to ON
OFF
The DTR signal from DTE
goes through the card
2
ON
Forcibly turning the RTS/C
signal to ON
OFF
The RTS/C signal from
DTE goes through the
card
3
Not used
4
ON
V.11 (X.21) interface
OFF
V.24/V.28 (RS-232C)
interface
5
ON
No. 1
Circuit
Forcibly turning the DTR
signal to ON
OFF
The DTR signal from DTE
goes through the card
6
ON
Forcibly turning the RTS/C
signal to ON
OFF
The RTS/C signal from
DTE goes through the
card
7
Not used
8
ON
V.11 (X.21) interface
OFF
V.24/V.28 (RS-232C)
interface
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION
CHECK
1 2 3 4 5 6 7 8
ON
OFF
OFF
