CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
PN-BRTA (BRT)
NEAX2000 IVS
2
Installation Procedure Manual
ND-70928 (E), Issue 1.0
Page 241
The figure in the SWITCH NAME column and the position in
in the SETTING POSITION
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and
, the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/unplug-
ging the circuit card.
SW1 (DIP SW)
1
For terminating the transmitting side
of channels B1 and B2 with 100
ohms.
OFF
To remove the terminating resistor
on the transmitting side of channels
B1 and B2.
2
For terminating the receiving side of
channels B1 and B2 with 100 ohms.
OFF
To remove the terminating resistor
on the receiving side of channels B1
and B2.
(Continued)
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION
CHECK
1 2
ON
ON
ON
