NEC IT3510, Operation Manual

Page: 396 / 466

6 - 32 Advanced Sending and Receiving Operations
Issue 1 NEC IT Series
Remote Multi-Copies:
The sender can specify the number of copies to be printed at the receiving
side.
Procedure for Remote Multi-Copying:
Specify the F CODE (SUB) as follows:
F CODE Password Transmissions:
The NEC IT3510/IT2510 only receives transmissions when the F CODE
password matches. An F CODE password can be registered for each
mailbox.
F CODE Password Reception
Set the Remote Input Check to ON when registering users. Refer
to Section 2.15 Registering Users in Chapter 3 Registration and
Setting Operations on page 3-37.
Details on setting an F CODE:
When the NEC IT3510/IT2510 receives an F CODE, it first searches for the
F CODE from the Bulletin Board (1 to 10), and if there is no appropriate F
CODE, it goes on to search the mailboxes (1 to 100) that have been set for
each user. Thus, if the same F CODE has been set for a mailbox and a
Bulletin Board, the Bulletin Board takes priority, and any documents that have
been sent to the user mailbox are registered on the Bulletin Board. In this
case, not only are the documents not received at the mailbox, the documents
already registered on the Bulletin Board are replaced, as well.
,
02
,
05
Specifies the desired number of copies to
be printed at the receiving end.
Function code:
Specify ’02’ for the Remote Multi-Copying
function.
It is very important to ensure that when an F CODE is selected
for each mailbox, it does not duplicate one which has also been
assigned to a Bulletin Board.