48
Figure 83
34)
Reconnect the cables that were previously disconnected in steps 7) – 10).
35)
On side A Acquire the tamper prevention plate and screws that were retained in
step 12).
36)
Locate the DC wiring assembly cable attached to the power supply with the Invenco
Link attached to it.
37)
Feed the open end of the DC wiring assembly cable through the opening on the
tamper prevention shield and plug it into the OPT Terminal labeled “VDC.” See
Figure 84
Figure 84
38)
Re-fasten the tamper prevention shield to the back of the OPT.
39)
Locate the Earth Ground Cables that is pre-wired to the Power Supply with the
Invenco Link and attach the female spade terminal to the male spade stud on the
OPT unit’s paper spool. See Figure 85.
Summary of Contents for 6003-K001-V003
